Last time we talked about the shop, I pointed out that the machine room floors needed to be refinished, like the bench room.

Difference in the floor between the two rooms

We thought we might be able to live with it, but after many dirty knees while working on machines trying to get them online that did not prove to be the true. The Yates American 36″ bandsaw, the radial arm saw station and the table saw island proved too big to move, so we decided to sand and finish around them. Here you can see the machine room with most of the machinery pushed into the empty space at the East end of the shop.

North wall of the shop before sanding

North West Corner Before Sanding

Table Saw Island

South East Corner

While this set back was frustrating, in the end the results definitely were worth the effort and time. Besides, we have become highly efficient at sanding and finishing floors. The entire process took three days. And here are the finished results.

Planer was pivoted out of our space on a pallet jack

Lathes Back In Place

East Side

West Side

South Side

-CB-

Machine Room Coming Together

Midstream of Machine Room Build-out

Machine room with ductwork plan

After some careful planning on paper, see “Planning the New Studio“, we massed all our machinery at the shop.

We were able to move James’ equipment out of his old shop and up to Lawrence in two trips in a 22 foot Penske truck. It went pretty seamlessly since everything was on wheels or on pallets, and I had recently found a pallet jack on Craigslist.

Don was bringing over his 8-inch jointer from his basement shop and we were able to muscle it out of his basement with four guys and some elbow grease.

I was not as lucky. Most of my machinery is 40 plus years old, cast iron and enormous. Adding that to the fact that my old shop did not have a loading dock, I needed to hire a rigger. As luck would have it, a machine I recently purchased from IRS Auctions was located at a rigger’s shop, so he agreed to bring it over and pick up all the other machines for a reasonable rate.

Enter Mike Kane of Woodworking Machinery Services and his amazing transforming truck. It basically is a 18 wheeler trailer that operates like a flat bed truck. He was easily able to unload his fork lift and move about 10,000 Lbs of machinery in a about a half an hour.

After all the machinery was at the shop, we started to move the machinery into position, bring electricity to them and hook up the dust collection system. Early on we decided to try to use the two dust collectors, a small Penn State and an Onieda, that we had rather than purchase a new/used one.

Onieda Installed With Duct Work

We built a small Stub wall to hold the Penn State dust collector, which will service the Wadkins 24-inch planer and the south wall, which has two lathes, three shapers and drops for a mobile sanding station.

Here is the run from the Onieda along the north wall that services the two jointers, the radial arm saw, and the three band-saws.

Duct Work on the North Wall

The Onieda also services the table saw island and the area that we are calling a tool corral, that houses router tables, William and Hussey molder planer, Dewalt Planer, scroll saw, and our 37-inch Performax drum sander.

Table Saw Island Coming Together

We had to raise the SawStop about 2 inches off the ground so that it would be level with the Oliver 260-D, a dual arbor sliding table saw. Here is the table saw island coming together.

Table Saw Island Nearing Completion

I have some trepidation about these dust collectors keeping up with all the machinery, but we thought we would give it a try first and then upgrade as necessary. Also we plan on eliminating the filter assembly and venting the fine particle out the shop window to improve their efficiency, being 6 floors up has some benefits. Adding blast gates to isolate entire runs, as well as at each machine, would also improve efficiency.

Time will tell if these two smaller dust collectors will be able to keep up with three people in a busy shop.

-CB-